Apogee used metric nuts and screws for all our products until the Symphony I/O which uses Imperial.
For example, back of Rosetta-800 dsub nut accepts 2.6mm thread from a breakout cable. The imperial size that’s close to this is 440 SAE and that is used on Symphony I/O and later.
If you need these screws, they must be purchased on your own. Use the following information to search for these parts at 3rd-party sites & hardware stores:
Rosetta/16x metric DB25 Hex nuts
- STANDOFF JACK SCREW 2.6mm ???
- NOT AVAILABLE FOR CUSTOMER PURCHASE
Symphony DB25 Imperial Hex nuts
- STANDOFF JACK SCREW 4-40 3/16”
- NOT AVAILABLE FOR CUSTOMER PURCHASE
Symphony I/O Rack ear screws (into Symphony frame)
- SCREW 6-32 x .375 PH. UNDERCUT FLAT HEAD, BLACK
- Top panel screws
Top Panel Screws
- 4-40 ¼ PHIL flat-head blk
Rear panel round pan-head screws
- 4-40 ¼ PHIL PAN EXT Black
Symphony I/O module Standoffs
- 4-40 1.5” length, ¼” Hex M-F STANDOFFS Aluminum
- Available Internationally from DigiKey: https://www.digikey.com/en/products/detail/keystone-electronics/8409/255376
x-series card standoffs - NO LONGER AVAILABLE
- 2 x …. Standoff ⅝ ¼ Hex 4-40 Aluminum
- 1 x …. Mini PCB Support (plastic)
Comments
0 comments
Article is closed for comments.