How to set the Symphony I/O MkII for Auto-Power On
Chris
Updated
Power down the Symphony I/O MkII.
Disconnect Thunderbolt cable and power cable from Symphony I/O MkII.
Unscrew the top lid from the Symphony I/O MkII chassis.
Once the lid is off, look down at the Main Digital board (the board on the left).
In the lower right-side corner of the Main Digital board, near where the orange ribbon cables connect the front-panel display to the Main Digital board and the gray ribbon cables connect the i/o modules to the Main Digital board, you will see jumper J18 with the words 'Auto Power On'. Move the jumper over to the right so it is covering pins 2 and 3.
Put the top lid back on the chassis and now the Symphony I/O MkII is set for Auto-Power On.
Comments
0 comments
Article is closed for comments.